Recent content by Blue86Monte

Going to a SBC now?

I was finally able to get the car out of the trailer and start working on the car. We are going to take it to the track in the next week pending we get some bugs worked out. This car came from a guy on Maliburacing.com up in Wichita Kansas. Car came with a 9 inch Ford, 406 SBC , RHS cast...

Little better picture of the car.

We have Pypes exhaust on 2 of the 3 of our cars. They fit great, very minimal trimming needed. No rust on them yet, I would recommend them!

Car is looking great, keep up with work. This build gives me motivation to work on my junk.

There is not hate here at all, I have picked up many useful facts from DoubleV. Might just be trying to get under his skin a little bit..

'78 Malibu Wagon, Details are in signature.

We fixed that problem by putting graphite into the speedometer cable and speedometer itself. In the back where the cable insets in the unit. It helped for a while, but after a few thousand it went back bouncing. If you are really fed up with, I would think a new speedometer itself would fix...

Coming from a guy that has someone else build his motor?

Anyone want to help put a small block chevy in my Hurst/Olds this weekend? :D

Low 12's shouldn't be a problem. May run into problems with traction, but nothing a set of drag radials wont fix! Good luck and have fun!

This setup looks absolutely crazy!

Going to get the block checked out here next week. Still need to order main caps, main studs, and some other mic goodies. Thanks for looking, Cory

8 inch rim is what you want to run.

Brad Penn in all three of our cars. One has 383 with Flat Tappet cam. Other a 406 Roller motor on E85. The new motor will be on Brad Penn too. Best oil out there hands down, plus it's green.