you can drop the rear of the fender down by taking out 1 shim in the top rear of fender open hood the one tall bolt there might be a shim under the fender and loosen the bolt under the rear of the fender you mighr have to add a shim there also the fender is to far in on the bottom there are...
just used dum dum like the factory did you will see it when you unscrew the channels the stuff never gets hard but seals out water you will have to gently pry the channels off it a little sticky
after i did all the adjustments i still had that gap then i took the weatherstripping out and moved the channel out ward and drilled new holes no more wind noise
does the hood line up ? if so good . in your pics with the absorber un bolted looks like where the bolts are in the frame that flange is bent a little 'straighten that flange out no big deal if that is bent the flange on the absorber is also bent measure the length of the absorber it needs to...
can;t see them in your picture are they the same black plastic the strips are made of ? if so they are probably part of the strip not made to come out but you can hammer a screwdriver with the tip on the black plastic on one side then the other better pic will help are you putting on new strips ?
the computer doe;s not need feedback from the egr so yes you can delete it you nox emissions will go up the egr pumps exhaust in the cylinders while cruising when power is not needed saving gas and lowering combustion temps.. high combustion temps produce more nox emissions i would keep...
you might have to change the distributor it works with the original carb and computer and 02 set up take out the carb and you won;t have any advance i don;t know anything about your efi set up .probably have to go with a stand alone dist 1980 or earlier
check to see if it has power with key on and key off headlight on and off it would be best if it only comes on with the lights ..it could be a plug to the heater controls or maybe the cigarette lighter i know they have different cigarette lighter plugs they will vary with the year
any auto paint store can match the color you will need a paint gun .its good for hard plastic parts ..when you say seat bottom i hope you are not talking about the part you sit on it;s to flexable
before you pull the carb check the vacuum ports the manifold vacuum ones will have vacuum at idle the timmed or ported ones won;t have vacuum at idle they only have vacuum at higher rpm
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.