CopperNick
Comic Book Super Hero From Canada
- Joined
- Last seen
- Viewing thread 1964 Skylark Coupe Project
Latest activity Postings Media Albums About
-
-
CopperNick replied to the thread BUILD THREAD 79 Monte round 2.Great technical shots of the roof structure!! Would'ya mind if i grabbed copies from your post for my own build?? Appreciate it... -
CopperNick replied to the thread What did you do to your non-G body project today? [2023].Finally managed to locate the remaining portion of that roll of self adhering/sealing tape that I just knew I had stashed somewhere...
-
CopperNick replied to the thread What did you do to your non-G body project today? [2023].Possilble that an intensive hands on seminar complete with grease and oil immersion might remedy the lack of care being exhibited? Nick
-
CopperNick reacted to Supercharged111's post in the thread What did you do to your non-G body project today? [2023] with
Agree.
Ahh. Well I do know that rear main seal cover was prone to porosity issues that would lead to leakage. I wonder if your little pocket... -
CopperNick replied to the thread BUICK 1964 Skylark Coupe Project.Wouldn't be surprised to learn that they were sourced from either Brazil or Argentina. A lot of the old dead stamping dies were sent...
-
CopperNick replied to the thread What are you drinking tonight?.Have heard of Jack Black but Double Black is a new one for me. Must be fairly new and not likely to be available up here due to...
-
CopperNick replied to the thread What did you do to your shop today?.Now that adaptor is SLICK. Where'd you find it? Nick
-
CopperNick replied to the thread What did you do to your non-G body project today? [2023].Haven't had to hold a Delco Plug up for a mark 0 mod 1 eyeball lookee-see in more minutes than I care to remember. I do know that I...
-
CopperNick replied to the thread What did you do to your non-G body project today? [2023].Parked the mechanical to do's in favor of dealing with my urban garden issues. Finally cut the steel repair stakes to length and...
-
CopperNick replied to the thread What did you do to your non-G body project today? [2023].So the electrodes on the plugs have seemingly left the building and the mill still ran??? I've heard of recessed 'trodes but buried...
-
CopperNick replied to the thread Two-port Fuel Vapor Canister Recharge/Refurbish.Yeah, that would be about right. Around here the bottom replaceable foam filters used to be available but not sure anymore if their...
-
CopperNick replied to the thread Two-port Fuel Vapor Canister Recharge/Refurbish.'ve replaced the foams but never considered filleting the canister to replace the carbon purification medium. interesting. Nick
-
CopperNick replied to the thread What did you do to your non-G body project today? [2023].Lemmesee here...............aye'yuh, it's been around 46 years +/- since I put a hook anywhere near water, never mind got any kind of...
-
CopperNick reacted to Texas82GP's post in the thread What did you do to your non-G body project today? [2023] with
Haha.
It really wasn't that bad. Pull the plug wires off the coils, pull the coils as an assembly and then 4 bolts and the cover is off... -
CopperNick replied to the thread What is this fitting on a Saginaw style power steering pump?.An AN fitting, aka an Army-Navy fitting, also uses its own standard thread size. AN fittings are a flare fitting, using 37° flared...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
